Product Manual
RFD900x Multipoint User Manual
RFD900x Multipoint User Manual
Multipoint firmware User Manual
For use on the RFD x/ux/ux-SMT modems, Multipoint Firmware versions 2.86+
RFDesign SiK Software manual
SiK Software solution (see Useful Links) is an open source development which is also compatible with RFD900 Modem Tools.
RFD900x Peer to peer User Manual
RFD900x Peer to peer User Manual
902-928MHz frequency band
Configuration and usage guide
Flash Programmer User Manual
RFD900x DataSheet Manual
RFD900x DataSheet Manual : Product Specifications and Performance Flash Programmer User Manual
Mauch 031 PDB Manual
Mauch 031 PDB was specially designed for the Pixhawk 2.1 (aka The Cube) with integrated 2 x 200A hall sensor current measurements, Sensor Hub X2, 4-14S HYB-BEC and most important a main power switch with the capability to withstand a current of continues 400A.
Mauch Power-Cube 1 / V3 Manual
The Power-Cube series was developed in response to the increasing power demand of bigger UAV-s together with the new Pixhawk 2.1. The installed equipment, such as heated IMU’s, optical flow sensors, OSD, dual GPS, telemetry, companion computers, gimbal, camera, landing gear, parachute, digital servos, LED-s, Raspberry Pi 3, Lidar require additional and more reliable and robust power supply.
Lipo Battery Guide
Lipo Battery Guide What’s a Lipo battery? Lipo Battery, its full name is lithium polymer battery, people also called Li-po battery, or more correctly lithium-ion
Skydroid H12 Manual
Skydroid H12 2.4Ghz long range radio can reach 5 to 30km. It has clear image, low delay, long range, strong anti-interference and other features. So it can be widely used on agriculture drones, FPV sevurity, fire protection, electric power, surveying and mapping robots, border defenses, etc.
Skydroid T12 Manual
Skydroid T12 Manual: 1.Connect to cellphone APP 2.Receiver / Camera / FC Connection and Setting 3.Connect to Cellphone to Display the Video
Ardupilot Camera Shutter Configuration
Ardupilot Camera Shutter Configuration:PWM trigger & Relay trigger
PX4 Autopilot User Guide-Battery and Power Module Setup
PX4 Autopilot User Guide-Battery and Power Module Setup
Communicating with Raspberry Pi via MAVLink
This page explains how to connect and configure a Raspberry Pi (RPi) so that it is able to communicate with a flight controller using the MAVLink protocol over a serial connection. This can be used to perform additional tasks such as image recognition which simply cannot be done by the flight controller due to the memory requirements for storing images.
